Search results

Have 1 point on drivers side it leaks a tiny bit. Started after internal cleaning stuff. (QMI internal engine cleaning) And changed oil 3 times. But used the wrong oil. It's for diesel but 10w40 grade.

New cover? Wtf. Or gasket?

Well. Haven't been a problem here yet. But it is on to do list. Not pulling heavy. And, it's Norway. Haven't been over 50 degrees Fahrenheit yet. It's cool to touch. In the front it's open to all the water and salt on the roads. Then over heat isn't a problem. 🤣 But corrosion. 🤔🤣 But it was...

Just ordered cover gasket and lifter

I have one valve lifter that makes a tick sound. Hear it more when hot. Changed oil 3 times and did a qmi clean of inside engine. Got better for a while but back on now. Afraid to drive it because of that lifter. But sounds i talk about is general hard running until cylinders get a little...

My 1995 is much more quiet on start. It's 250000 km (155000 miles) on the engine.

Try to share link to YouTube video of 1999 Chevrolet Tahoe Goodwrench 6.5td engine start.

Got it in December. And yes it always make the same sound. Changed even pmd but same.

Offset is - 0.7

I will make a video. Light in dash works. I know this because before I made a mechanical wastegate it threw codes on under or no boost . Light is ok. Starts easy. Even - 2 degrees Celsius. It runs hard for 10-60 seconds. Like cold start system. Advanced timing says 14-16 degrees on obd2 reader...

A couple of questions. Seems that this is a 2002 engine. Found diamond in the walley. Real hard running sound at startup for a few seconds. What can cause this? Nr 9 resistor in pmd. Found a (what I think is) a boost fooler. Do not get any codes/engine light. Use manual wastegate spring...