Nosferatu49534
Well-Known Member
Does any one know what the name of this bushing is? Its split in half and I have know idea what to search for parts wise. Its where the cross member for the torsion bars attached attaches to the frame.
-
Welcome to The Truck Stop! We see you haven't REGISTERED yet.
Your truck knowledge is missing!
- Registration is FREE , all we need is your birthday and email. (We don't share ANY data with ANYONE)
- We have tons of knowledge here for your diesel truck!
- Post your own topics and reply to existing threads to help others out!
- NO ADS! The site is fully functional and ad free!
Problems registering? Click here to contact us!
Already registered, but need a PASSWORD RESET? CLICK HERE TO RESET YOUR PASSWORD!
What is this?
- Thread starter Nosferatu49534
- Start date
79jasper
Active Member
Try torsion bar mount.
Moog K6443.
Might be right, might be wrong. Lol
Sent from my SM-G892A using Tapatalk
Moog K6443.
Might be right, might be wrong. Lol
Sent from my SM-G892A using Tapatalk
Nosferatu49534
Well-Known Member
Not the right one. Thanks though.
I don't know why this thing is so hard to find.
I found a picture from a forum about S-we'd. [emoji53]
- Staff
- #4
I always had to get them from the dealer. They're the torsion bar cross member mount bushings. Think they were $13 a piece ladt ones I bought.
Nosferatu49534
Well-Known Member
I will have to try that route. Thanks.
MrMarty51
Well-Known Member
I did a total rebuild on a 95 S10, engine and clutch.
After getting the wehicle back together and driving it, there was a loud rattle noise coming from under it. Got to checking things out and one of those mounts was busted.
I do not remember the process of removing the old one and installing the new one, but there was something to it, new mount was modified somehow to make installation a lot easier.
After getting the wehicle back together and driving it, there was a loud rattle noise coming from under it. Got to checking things out and one of those mounts was busted.
I do not remember the process of removing the old one and installing the new one, but there was something to it, new mount was modified somehow to make installation a lot easier.
smokymtn65
Well-Known Member
GM calls them Support Insulator 2082913 , 15001006 Few related P/N
- Staff
- #8
Gotta remove both torsion bars to replace them as the cross member must be slid at an angle to get them off and new ones on. I had my whole front end apart, and still cussed doing them as I have NO room around that crossmember with the np261xhdc transfer case.
MrMarty51
Well-Known Member
I remember there was quite a bit to replacing them, and it was a bit of a pain. I just could not remember all of the details.
Nosferatu49534
Well-Known Member
Yeah I might not do them myself. [emoji3] I've got a great mechanic for the stuff that I don't feel ambitious enough to do. [emoji41]