ZF6 measurement

[GM Guy]

Does anyone know offhand what the bellhousing to shifter stub measurement is? I was wondering if a ZF6 shifter would line up with the factory hole on the C/K. I know driveline work is needed for a NV to ZF swap, but i was wondering if at least something would line up.

Thanks!:thumbsup:

 

[01duramax6spd]

I'll measure. One of mine is out currently.

 

[GM Guy]

thanks! i am still wondering if a ZF6 will go in easy, probably won't but we'll see!

if it will fit w/o body lift or tunnel modding w/ sledge, just driveshaft, (also prefer minimal mods to crossmember) it will be a high possibility. i also wonder how the clutch will work. i would also like the shifter to fit in perfectly. basically would like as close to bolt in as possible.

 

[01duramax6spd]

It's 34" long but haven't pulled a bell to shifter emasurement yet. 4x4 version.

 

[GM Guy]

Thanks! you know me, 2wd is preferred, (and easier in this case!) i pretty well know that the driveline will need shortening, as the ZF6 is surely longer, but i am just concerned w/ the bellhousing face to shifter stub measurement (surely this is the most accurate way, right?) to see if it will fit in the hole in the floor.

thanks for measuring! :thumbsup:

 

[01duramax6spd]

I forgot to get measurements today. I have trans at buddys shop right now for a rebuild. if I can remember I'll measure it tomorrow if I make it up there.

 

[GM Guy]

Thank you very much sir!:thumbsup: