Hino 300 ABS dash light

[Greentouch]

Hi all
This ABS dash light came on, that indicated that the front brakes were low and needed to be replaced
So I did the brakes, as in.. new rotors & pads and 1 of the callipers was leaking brake fluid and it was replaced as well.. and everything is now working well
Now.. how to reset the ABS sensor on this Hino 2010 300 please?

 

[dbrannon79]

you will need a scanner to reset the ABS light. when you bleed out the brakes, were you getting good flow and pressure to the leaking caliper side? if not, you will need to look for the purportioning valve, it's a block where all the steel brake lines connect from the master cylinder and then lead out to the wheels. there will be a pin on the side to push to reset it. but if it's flowing brake fluid good to each wheel, you don't need to worry with it. the valve is like a safety feature for when one of the wheels looses pressure it will divert all available pressure to the "working" wheels.


ABS lights up normally with a bad speed sensor or low brake pressure. but if there is low brake pressure, the red brake light will be on too.

if only the ABS is on, then it will be a speed sensor in most cases.

 

[Greentouch]

you will need a scanner to reset the ABS light. when you bleed out the brakes, were you getting good flow and pressure to the leaking caliper side? if not, you will need to look for the purportioning valve, it's a block where all the steel brake lines connect from the master cylinder and then lead out to the wheels. there will be a pin on the side to push to reset it. but if it's flowing brake fluid good to each wheel, you don't need to worry with it. the valve is like a safety feature for when one of the wheels looses pressure it will divert all available pressure to the "working" wheels.


ABS lights up normally with a bad speed sensor or low brake pressure. but if there is low brake pressure, the red brake light will be on too.

if only the ABS is on, then it will be a speed sensor in most cases.

Thank you

 

[MrMarty51]

I have the Autel Maxi AP200 ALDL adapter. It comes with one vehicle brand. I chose GM.
Installed new front brakes on My 2000 K3500 and could not get the right side to flow.
conected the adapter to the phone through the blue tooth then after getting VIN loaded, it reads that for You, then poked around in the various programs and found the ABS tool, brought that up. It would not allow Me to bleed the ABS as there was a code.
Did the ABS code read, then cleared the code.
Went back through and the app led Me through the ABS bleed procedure.
That is the best $65.00 I have ever spent for a code reader device.
Thank You @Quad star tuning for guiding Me into this purchase.

 

[Greentouch]

I have the Autel Maxi AP200 ALDL adapter. It comes with one vehicle brand. I chose GM.
Installed new front brakes on My 2000 K3500 and could not get the right side to flow.
conected the adapter to the phone through the blue tooth then after getting VIN loaded, it reads that for You, then poked around in the various programs and found the ABS tool, brought that up. It would not allow Me to bleed the ABS as there was a code.
Did the ABS code read, then cleared the code.
Went back through and the app led Me through the ABS bleed procedure.
That is the best $65.00 I have ever spent for a code reader device.
Thank You @Quad star tuning for guiding Me into this purchase.

Thank you