For Dashboards needing repair

[RI Chevy Silveradoman]

1997-1999 Chevy/GMC C/K Pickup Suburban Yukon Tahoe Escalade Dash Cove

Fix or restore your cracked or worn dash with an ABS molded overlay cover from DashSkin. Mounts over your existing dash in 30 minutes or less.

dashskin.com

This was for certain model year. Be sure to hit home and choose your correct model year and application.

 

[Will L.]

I’m soon to order one for our 2013 tahoe (ex cop car). It needs a new blower motor and maybe sensor for auto headlights first. Debating dropping it at a shop rather than diy for the lights & blower. Found middle seats & center console but they and both front seats need recovering.
Too many irons and a bic lighter as the fire right now.

I never did a dash cover like this one but they are pretty simple.

 

[smokymtn65]

@Will L. Blower motor (front) isn't to bad to change. Typical GM 7mm is a spot or two that you have to get a bit creative.

 

[RI Chevy Silveradoman]

There are many companies selling nice leather seat covers that aren't too bad to install and look just as good if not better than factory.

 

[Will L.]

There are many companies selling nice leather seat covers that aren't too bad to install and look just as good if not better than factory.

Yeah, trying to look through them and determine best option.
I’m open to experience people have in different companies.

I used the “wetsuit” brand covers in the FJ Cruiser. They held up ok for a few years. The driver seat tore just like the gm ones do where you slide in past the edge. The look good but are obvious after market covers. For the tahoe I prefer to find something that either is actual upholstery or looks just like it rather than the loose fit slip cover look.

 

[RI Chevy Silveradoman]

There is some made of leather that are supposed to be the Cats A$$.

 

[SnowDrift]

Does anyone know if the '97+ dash cover fits the '95--'96 trucks?

 

[jrsavoie]

@Will L. Blower motor (front) isn't to bad to change. Typical GM 7mm is a spot or two that you have to get a bit creative.

I found uses for my little Craftsman battery 1/4" drive ratchet on that project as well