Will L.
Well-Known Member
I don’t have access to all data or the like anymore. Hoping someone onows something or could look up for me if you have access...
2005 Escalade esv full time 4wd with a 6.0
Everything great since we bought and started driving 2 years 8 months ago.
Battery was dead so new Oriellys battery since big credit was due from them. Also didn’t know if we would keep truck or not so was being cheap I guess. (ugg- dont do battery again from them).
Battery had slow 1 week death and replaced after fighting under warranty. In mean time with low voltage all gauges went bonkers, and 2 codes. Knock sensor bank 2, and oil pressure sensor failure code.
After new battery check engine still on and oil pressure gauges goes from under 0 to 80 pin (both above “max”) the check engine light isnt backnon yet, but gauge pegged at 80, soon as it bounces again it will.
I know the knock sensor harness by the starter is subject to overheat and issues.
But I know nothing of the oil pressure sensor on these 6.0, or any gen 4 ls engines goofing up. Also don’t know of harness issues.
Everything else is back to normal. I will keep the Oriellys hard to warranty battery through 2/2019 when warranty ends, then when it dies it will get a proper agm battery.
Going to do The whole remove and clean thing with my fingers crossed.
Any help or input is appreciated.
2005 Escalade esv full time 4wd with a 6.0
Everything great since we bought and started driving 2 years 8 months ago.
Battery was dead so new Oriellys battery since big credit was due from them. Also didn’t know if we would keep truck or not so was being cheap I guess. (ugg- dont do battery again from them).
Battery had slow 1 week death and replaced after fighting under warranty. In mean time with low voltage all gauges went bonkers, and 2 codes. Knock sensor bank 2, and oil pressure sensor failure code.
After new battery check engine still on and oil pressure gauges goes from under 0 to 80 pin (both above “max”) the check engine light isnt backnon yet, but gauge pegged at 80, soon as it bounces again it will.
I know the knock sensor harness by the starter is subject to overheat and issues.
But I know nothing of the oil pressure sensor on these 6.0, or any gen 4 ls engines goofing up. Also don’t know of harness issues.
Everything else is back to normal. I will keep the Oriellys hard to warranty battery through 2/2019 when warranty ends, then when it dies it will get a proper agm battery.
Going to do The whole remove and clean thing with my fingers crossed.
Any help or input is appreciated.