Search results

thanks everybody. I am still lost. I have the bundle splitting off from from engine bundle..runs donw left side of engine. it has thrre connectors for a/c compressor and a two pins male connector that the wires are white & brown. I have glow plugs already connected and water temp sensor in left...

I thought or that. no junk yards in 100 miles have engine still installed

does anyone have a wiring harness diagram that shows where components are plugged into. especially pics of crank position sensor and injection pump pics would be way helpful. I have to admit I am a lil over my head with this project.

I have it cps connected to y lead at injection pump currently. you are right the connectors don't match. there is a connector already in position by power steering pump. and one in left head forward , that appears to be a water temp sensor. I am not second guessing my marking. LOLOL I am...

thanks big T. I am still confused. when I pulled the engine it had a sensor left lower side by harmonic dampener. it had a tab with one bolt holding it in. it had a short electrical lead approx. 6 ". when I purchased a new CPS (old one I couldn't get out without destroying it) it came with a...

good morning. I am pulling my hair out on this wiring harness underhood of my 1997 k2500 ext cab. there is a harness that splits off engine main harness and runs down left side of engine. there are three connectors for the air conditioning compressor and one that I cant not find where it plugs...

its a 1997 k2500 ext cab

ok. i got another question..... the wiring harness that runs along left side of engine has three connector plugs two go to my air conditioning compressor and the third i marked as crank position snsor when i removed engine over a year ago. i installed a new crank position sensor before...

thank you soooo much. been pulling my hair out with this one. i thought that was were it went. i just didnt want to take intake back off again..

does it have to be mounted under the intake? or does it go on after the intake is mounted? i knew i didnt take enuf pictures

thats it!!! it has two clips for mounting it. i assume it connects to the crossover line between the left and right bank.i have intake off and wanted to ensure it went on prior to me seeting the intake. is there any pictures showing this line and where it actually bolts to?

truck is a 1997 k2500 ext cab. i bought a us engine production drop in. the first steel line runs btween fuel injectors on front of engine to return fuel from injectors to tank. i can see where that one goes. the other line has 90 degree bend on both end of steel line. approx 18 inches long...

i bought a drop in reman. had to return core a year ago and can not remeber where fuel lines go, i got it narrowed down but have a 3/8" pipe about 18 inches long with 90 degree bend on one end that is stumping me. can anyone help?