Search results

Thanks Will I’ll post a video.

Thanks, the PMD that is on there now is the one on my truck before I changed the motor. It should be good the truck was running fine. I have all new sensors and IP. Also a new upper engine harness from Quadstar. I don’t think I have that noise filter w/ the new harness, I will...

Ok I’m trying again.

Don’t know why it was taken down I’ll try again

Ok guys I made some videos of my truck on start up and run. Also there are a couple cylinder balance tests. I did not smell any diesel fuel at the tailpipe. There is no way I could hold the RPM,s steady off idle during the cylinder balance test. Ok there is 1 cold start video had...

I got the rebuilt IP from Quadstar couldn’t get a new one. You think it could be a bad IP? I did not get any IP related codes. Had no trouble doing the Time Set and TDC Offset Learn. The only codes were in the history, cylinder balance codes and looks to be the same 4 Or 5 cylinder...

Sorry I have it in my signature as LP instead of IP. I’ll have it edit it. It’s a new DS4.

Sorry my bad again. The dtc,s in the history were only 91,94,95,96 and 97 not 91 through 98 cylinder balance errors, along w/ dtc. #88 TDC Offset Error, I got them before when I was going through the Time Set and TDC Offset Learn. I’m going to see if dtc,s 91,94,95,96 and 97 come back...

Finally got the Time set at around 3.5 and TDC Offset Learn -35 to -44. Still misses and dies when in gear. No currant DTC,s. But does have DTC,s in history cylinder balance #91 through #98. Assuming bad new AC Delco injectors. What do you guys think? Here’s some videos on how rough it runs

I’m going to go out to set the timing tomorrow ( w/ 97’ timing procedures ) after a good night sleep so that I’m thinking clearly 💁 I’m going to check and adjust IP timing in the TDC Time Set Test to Measured Ing. Time 3.5. Then attempt TDC Offset. Warm engine up or use the coolant...

Hi , is there a way to get the Tech Library working? Thanks.

Can we contact administrtion?

Thanks guys I’m not only learning about these diesels also about computers Thanks again.

I can print page #2 but can’t print page #1. I believe because the blue + sign is cropped too much. Sorry for the trouble could you post the pages so I can print them. It will be a big help. Thanks.

I was just looking in the 95’ manual. I did see something like this in there but only using a Tech1. Was not sure about using it. Thanks very much.

Yea I’m on that site too. My iPad doesn’t like the site. Sometimes trouble entering text. Really slow. On here it’s OK. Don’t get it.

I’m assuming in the learning procedure there are steps to follow? Thanks so much.

Hi all I’ve been on here a lot lately w/ my new Optimizer build. All the guys on here are great and very helpful. Is the anyway I can get into 6.5 Technical Library to take advantage of the manuals on these trucks? I’ve tried several times w/ no luck. Maybe I’m doing something...

Sounds like I have to two steps. Actual timing first on the engine data screen and then go back to the learn portion. Do I have to do anything or does it learn on its own? Is the LP always that hard to move? Thanks