Search results

I'm guessing you also plan to use a couple of flex sections on the crossover?

@n8in8or Could you post a pic of how those flanges fit on the head around the glows and other humps on the mounting surface? Another question sense you are in the area, if a person used 1 1/4 diameter sch 10 ss pipe and connected 2 cylinders into 1 pipe, do you see room to have 2 crossover...

TSM either changed names or sold out.... https://www.rusticdiscbrakes.com/

Can't blame a guy for trying...

Nate, you and Kelli can come down for a few weeks vacation any time, I have a camper set up and ready... And I can keep you busy for a while so you don't get bored...

We allow northerners to visit but they have to go back north ... 😁

I can see the salt getting ready to attack this winter 😂... Looking good..

Wondering what material your going to make them out of?

I've got a bunch of nos Bosch injectors, new not rebuilt, military surplus. If you haven't bought a set yet I'll donate a set to you... I'm a AF vet so call it paying it forward if needed...

Yes the drain valve is still available........................ https://real4wd.com/product/cock-drain-fuel-water-separator/

No, lift pump should be running...

After all these issues and the guarantee of issues in the future it would be worth thinking about a db2 swap...

This is how I cut the broken bolt hole. Another view from the front. Looking from the TOP, the bolt hole cut down the middle, you are looking at the lower portion . Then I cut this in half, there is a water jacket, the jacket is in the inside part of the bolt hole... My advice...

@DieselAmateur I'll see if I still have cutaways I did years ago. I also still have 1 scrap head I can section in that area. The thing with welding or brazing is the heat may bother the head gasket ...

Well that's reason enough to not buy it in my thinking..

I didn't realize the powerbond was a rubber clad balancer...

Wasn't sure, did you happen to check it like this when new?

What we looking at...

That just gives more places for air intrusion...

Normal HV spacer plate & the P400 spacer plate... both spacer plates are the same thickness...