Small bracket guard thing on power steering pump.

[hookedup50]

I was reinstalling the PS pump today and in the labled hardware there is a small guard about an inch and half long. Can anybody tell me the where abouts to install it. It looks like it came off the bottom near the oil cooler lines from the crud on it. Thanks again. I'm getting closer to starting this thing, then the fun begins with getting it to run right.

 

[WarWagon]

:nopics:

 

[hookedup50]

Sorry for no pics. I should have taken one with phone, but they always are sized funny. My truck is in Jersey and my camera in Ma, but going there tomorrow to recharge Bank account and will pick up camera

 

[Big T]

Is this on the engine block? Crank position sensor?

 

[hookedup50]

I'll try and take a pic of the thing and then try and upload it. Its not the CPS holder though, I have that installed. I'm concerned what will happen if I delete it. Kinda like the oil cooler holder that loosened itself off and killed the old engine by spewing 2 gallons of oil on the Jersey turnpike before I shut it down. Those lines should have been ss braid from the factory. The good news is the stressed cracked gm block is out of there and I upgraded everything I could afford.