• Welcome to The Truck Stop! We see you haven't REGISTERED yet.

    Your truck knowledge is missing!
    • Registration is FREE , all we need is your birthday and email. (We don't share ANY data with ANYONE)
    • We have tons of knowledge here for your diesel truck!
    • Post your own topics and reply to existing threads to help others out!
    • NO ADS! The site is fully functional and ad free!
    CLICK HERE TO REGISTER!

    Problems registering? Click here to contact us!

    Already registered, but need a PASSWORD RESET? CLICK HERE TO RESET YOUR PASSWORD!

installing heads

sshewins

sshewins

Jesus Freak
Messages
427
Reaction score
8
Location
Crystal Lake, IL
Hey guys, quick question here. I had the heads on the 95 milled about 2 or 3 years ago due to blown gaskets. Since then, I've only put about 5K miles on it. What's the consensus on having to mill them again if I pull them off in the near future? Got a few ideas I'm toying with and i just wasn't sure if re-milling would be necessary with so few miles and already had been machined.

Thanks in advance,
 
Take them to your local shop have them do an inspection and clean probably like 80.00. As long as both mating surfaces are clean you should be good.
 
I never milled a 6.2/6.5 head ,never seen a crooked one yet.
If i had to, i would do it on a surface grinder only,and with precups installed.
 
You must log in or register to reply here.
Back
Top