How would you turn over the motor?

[TravelingMan0491]

I was wondering if your starter happened to wear away enough of a section of the flex plate, what would be your preffered method of turning over the motor in order to get some fresh teeth exposed so that the starter could grab?

 

[3500GMC]

Shouldn't take much of a bump. Slide under and grab the crank pulley by the 'X' on the front. You should be able to get a small movement by hand.

 

[Twisted Steel Performance]

I'd try a socket on the alt pulley nut....

 

[bison]

Any one of the four 15 mm bolts holding the crank pulley to the damper.

 

[TravelingMan0491]

Thanks guys! Good to know!

 

[GM Guy]

ahhh. one of the reasons I buy what I buy. My answer is get it rolling and pop the clutch. but yeah, for the auto, I would try to roll it over via alt. pulley just to get it going. maybe a prybar between two front pulley bolts.