Big T
Well-Known Member
So when I opened the second of two boxes containing the front CV axles (Dorman Reman) I purchased from RockAuto, this one had punched out the cap on the inner connection. Some grease had come out and I stuffed that back in and used a mallet to tap the plate back on. I installed the axle, but it sticks out a couple inches further than the other side. I rotated it and tried to shove it back in. It went in some, but still sticks out further. What's going on and what do I need to do?
BTW www.MIBearings.com sent me the wrong bearing hubs.:mad2: The hubs they sent me have part #s 515058, BR930416, SP58013. These hubs have a round flange as opposed to a starred flange that fits into the rotor. Their website is lame for searching the parts. I will call them before I board the plane to get the right parts and return the wrong ones.
This project has just been murder.:rolleyes5:
BTW www.MIBearings.com sent me the wrong bearing hubs.:mad2: The hubs they sent me have part #s 515058, BR930416, SP58013. These hubs have a round flange as opposed to a starred flange that fits into the rotor. Their website is lame for searching the parts. I will call them before I board the plane to get the right parts and return the wrong ones.
This project has just been murder.:rolleyes5: