Search results

Is this the article that was mentioned which Bill Heath wrote when the single thermostat housings became desirable?

Are you running the HO pump on both @Big T ?

Mine got warmer than I like to see this past summer pulling our fifth wheel on flat ground for about a 10 mile trip. I had to turn off the A/C and haven't had to do that since before I replaced my radiator when I suspect it was plugged. The cavitation mentioned in that dieselpage article makes...

Husker said this: If a guy could obtain the unicorn, it sounds as though it's capable of doing the job, though, and allows a better fit for the DB2. Is that about right? I still wonder how much that '96 design will flow in comparison to the later dual thermostat design.

Thank you @Glagulator

Not thick enough to keep a broken crank from cracking it😁

On that rare 1996 crossover, was the water neck different than the 1995 version?

I contacted a few companies about their timing sets and learned about the chains and gears. The gears from all of these are said to be USA made. Cloyes chain from china Elgin chain from india Melling chain from india and Rolon is the manufacturer.

Burgoon is less than an hour and a half north of us.

What part of Ohio?

Mine doesn't see salt so I'm not as concerned but also understand your sentiments. The Banks Stinger exhaust I put on in '03 is without issue except where the flange connector has deteriorated over time. I almost bought the SS Diamond Eye when I was about finished with the engine installation...

There is a new one near me that is far less. I was wondering about the quality of pieces, and the joint at the downpipe

Are there negatives about this brand of exhaust system for our trucks? https://www.dirtydieselcustom.ca/products/1994-2000-duramax-6-5l-4-turbo-back-exhaust-flo-822?variant=7720630190116

Thanks for the information and links @Turbine Doc . I'm still not sure I want a bowl type under the truck so I'm considering these: https://kbdieselperformance.com/products/diesel-fuel-filter-remote-mount-base-for-1-14-filters?_pos=2&_sid=f63556597&_ss=r...

The sock has some trash on it but I didn't take time to get a picture. Based on what I've seen on it, though and how much I love removing fuel tanks, I'm thinking seriously about going with a 100 micron inline screen like what I posted earlier in this thread. If the factory sock is 70, then my...

We have changed a lot of CV boots over the years and have never replaced a whole shaft. I can't imagine doing it with only two hands though.

I wonder if @Glagulator has access to a p/n for it if that is what this is.

What does this rare 1996 version look like that I hear about? It was mentioned in the quote above from Husker This?

Is there any flow data to support this on the dual crossover?

Is one stainless and the other aluminized?