Search results

Thank you all very much. I'll get another pmd today. Or can they be tested. I know that orielly's can test ECM on most cars and trucks. But don't know about pmd

Found still on ip. And installed one from remote to ip

The original harness o I also checked the oil sending unit

Is there any place that I can take the pmd's to get them tested. And can the pmd go out that easy that if I took it out of running truck and installed it in mine that it could make it go bad. I'm not that up on them it's a newer truck than I had before I'm used to working on the older...

Ok yes the pmd was changed three times to three different pmd's. The ip was changed the fuel pump on frame rail was changed and the fuel relay was changed and I changed the crank sensor was changed. I did check the wiring on pump from pmd To the wiring harness plug and from the pmd to the...

Yes getting wait to start light. And didn't know about getting the PCM flashed. How do you do that the new ones they didn't tell me I needed them flashed. Do I need to get a code reader to flash them or is there a way to do it with out Sorry if some words are misspelled or if somethings...

Yes I have changed it three times And yes it was relocated to top of intake from ssdiesel I know it's a fuel problem but don't know if it's a wire that's bad or if I got three bad pcm's one was on the truck it's more than Likely bad the other was off running truck that came with ip And...

Ok so that's why it starts at wot this is the only problem I haven't been able to take care of. I'll the wiring on pumps good there's no power getting to the Pdm on back of ip. And every control mod I put on still don't get power to it there's four wires running to the ip wiring and only one...

Ok Pdm has been changed three times. I've put a pickup pump three PCM and a injection pump furl relay and crank sensor And still wond start and run

Hello guys thank you. I'm at my wits in here. Yes I've put three different PCM on it one new one off running truck and the old one. All of them are doing the same. I did put a 5volt power source to the back of ip and it started and ran but ran at wide open. Does the piece on rear of ip run...

I've cleaned all grounds and and the ECM on side of ip I also installed a heat sink ECM relocator

Hello new here. I'm in need of help I have a 95 Chevy 6.5 diesel. I'm having lots of trouble with any help thank you. Ok heres the problem. The truck didn't want to start cranks great I put a pick up pump in it and fuel relay. Got fuel to ip still no start up changed control mod ...