Search results

I was on another thread earlier, and stopped power probing and started wiggle test. The truck started with click of starter and stalled 5 seconds later. I wiggled around ECM again and it started again for 5 seconds. Now nothing. My ex has my service manual. Is there an ecm diagram for a 97...

I am a victim of this stupidity. I need a new isolator. The one from a vendor on here is very problematic

I’m watching this thread, and I will check for pinched wires, a few years years ago I changed the transmission, and intermittent running, but long cycles of running. I drove to Toronto and it hasn’t run since. My truck is set up similar to AK. There’s pressure to new ip, fuel exits the...

I'm game.

That's the unit. I used stainless steel scrubber inside, on the same theory as using it in my distiller. You probably have better insight than I on my theory. It's not alcohol in the vapor, but I've also not collected much as the optimizer from Ted's seems to gave little use and backed up with...

The only time my cats catch mice is when the bowl is almost empty. Now that the issue is fixed. I'll redo the ruined new interior. I replaced the bad rockers and cab corner that were a point of entry. The carpet may be salvaged with pressure spraying and carpet cleaner, but headliner is almost a...

I live out in the woods and own an old house with a partial stone, they are an issue with everything I own. All I can do is control their numbers. Poison is not an option as I worry about the dog and cats eating one, and having then die in the wall causes the stink that was in my truck.

I soldered the new plug on today and I have reverse lights. Like I mentioned earlier the wire next to the green backup wire had rubbed through and was hardly noticeable. Tomorrow I can drive the truck and get the rejection sticker off. I have to install the prefilter heater kit o next as the...

Update.... Now that the transmission is dead, and having no reverse lights had me looking at wiring under dash and to clean the mess they made, I tore out the remaining sound/ heat barrier, and found a 1 1/4 inch hole that whoever removed the plow system, never installed a grommet. It was up...

I found it on rock auto.

I opened what I thought was the 7 way female connector and it's not the right one. I know I saw them on a GM site . Is there a part number other than the one on the connector diagram. There's a TSM to change the connector, but I can't find that either. I found build your own 150 series...

I got back to the backup light issue today. With the key on and in reverse I have power in wire F, but still no lights as expected, because I haven't tracked down the issue yet. The thing I did notice is the light green wire has the insulation rubbed off at the plug and think it is or will...

Thanks for the warning. I'll have to consider this. I barely have use of my hands now and dropping things cause I can't feel them and it hurts at the same time. Not what I wanted to hear, but the truth is always best. There's so much gone wrong with me, having an issue get worse is worrying.

The input shaft open circuit was easy, as I must have bumped the plug off.

That's the story I got with my neck. Different pain and symptoms daily and deemed to risky to try anything. The only thing thy will fix is carpal tunnel from all the EMG testing. Meanwhile I have pain everywhere on any given day. Sorry to hear they won't or can't do anything. I poked around my...

I'm sorry, but can relate. I have the same diagnosis. Seven back surgeries and the rest I don't want to get into. I really appreciate your help because it save wear and tear on me. Thanks again.

Thank you, that helps a lot as I've no access to what wire does what, mostly cause I never had the need in the dozen years I've had this truck. All my other steel is precomputer and have had electrical issues, but I know what every wire goes to. Thanks again, and how are you feeling these days?

Thanks again, I ordered a new nsbu switch and thinking about new plugs as I think they maybe the issue. I am going to unplug and replug existing electronics , as they went in as hard as they came out. I really need to use this truck for a job.

That's the shaft from the shifter and there is the offset black rod that moves the that black switch.

What is this switch?