Search results

I'm sorry but I do not know what is the test in 2000 RPM. Tell me pls.

Sorry I forgot. 94 Chevy Suburban 6.5 diesel.

Hi! Sorry, I do not know how to say it correctly in English. Today my diesel presented a strange and unpleasant surprise. I was driving slowly in traffic. I did not touch the accelerator pedal. Suddenly diesel began to gain speed. I saw in the mirror black smoke. I braked and turned off the...

Oh yes of course. I remember about these rings. I can to pay for the ring $ 100 or $ 200, but I can not to pay them $ 800 or $ 1000. Which of these rings is better?

What kind of piston rings is better: Or

Hi everybody! My freind has Chevy Pickup 90. Hi both it whithout engine. Sum late hi both 6.2 desel removed from Suburban 84. And hi ask me about help. How to connect engine wiring 84 with pickup 90? Anybody have wiring diagram for 90?

Hi! Today my friend ask me about problem with cold advance control. 15 minutes after starting the engine stalls. If hi disconnect the connector from the cold advance control, then everything is OK. What is it?

Hi! Anybody help me to find the wiring diagram of 94 chevy 6,5 turbo pls.

Yes. It was PMD

Sorry. 94 Suburban 6,5 TD

Today I was driving home. Was very bad traffic. Suddenly my truck began to accelerate itself. I braked and stopped the truck to accelerate, but diesel stalled. I tried to start it. The diesel started, but accelerated above 2000 rpm and stalled. I tried again and again. The same result. What...

Thanks for your 2 cents! But do you see were am I from? In Russia is not a new shaft. I can bay it only in US. And the cost of the shipping from US to Russia will be much more expensive the price of shaft.

Info from military manual: If unable to obtain the proper crankshaft journal clearance, it is acceptable to use a standard bearing with a 0.0005 in. (0.013 mm) or 0.001 in. (0.025 mm) undersize bearing to produce clearance. If unable to produce proper clearance, replace crankshaft.

Hi! What should be the extreme size of the crankshaft repair? Rockauto.com sell bearings from 0.25 to 0.75mm. In the manual written only to 0.25mm. How long will the crankshaft after the repair to 0.5mm?

[ATTACH]42806[/ATTACH Cracking piece

I feel that you said something important but my English is not so good. I'm so sorry I don't understand what you said! Could you say a little easier?

Welder said the block needs to be heated in the oven. It's not bad for the engine?

I have good block with crack starter bolts hole. What do you think is it possible to repair this hole?

OK. May be you are right. I hope. This is very good for me.

What about the strain in the other cylinders?