Search results

Here is a link to n8in8or's build, and how he hooked up the cables. Might be able to get some idea's from some of his pictures http://www.thetruckstop.us/forum/threads/going-mechanical-with-a-moose-omega-marine-ip.45204/page-8

That looks a whole lot better than wearing a sore spot on a finger sliding it down the loom!

I believe the older ones would interfere with the AC compressor. I have a single stat for a 96 that is removed so if deejaaa can't get an angle on the P/N I will try to remember to look at it this evening

So the one in my pic that still has a plug in it? Also could you explain the bypass oil filter feed? I lack knowledge here.

Yea those old wiring diagrams are tough to read... I have a set that lines up better with my tahoe but they are not easier to read............

Thanks! I think between that and another wiring diagram I can get it to work........ So I guess that wire (pin J) sets the cruise control light in the panel? Guess I would not have to have it if I have a hard time finding that pin. I noticed it said "99-02 trucks" next to the speed sensor wire...

So Bobbie Martins guide says that pin J (the blue black wire) is not used, and that pin H which currently is empty should be connected to ground........ I am a little hesitant because his guide was written for OBDI trucks as far as I know. I don't think there would be a difference in this area...

@n8in8or It looks like I will be using a similar cruise set up to what you have. Do you remember where that wire went? I read through your post but it was either not mentioned or I missed it.

Got the cruise control harness pulled out. Looks like all will be easy to connect into the new harness except for one wire........... It goes to the computer, and is called "VCM signal" it is light blue with black stripe. Any of you guys running a mechanical swap and have a gasser cruise control...

It is an oldie............ So do I just plug the other two holes by the oil cooler lines?

It is taped to the harness under the dash by the steering column.

Just curious.... does anyone know what this little box is?

Tonight's progress was pulling the wires out of the tahoe's harness for the rear hatch and rear window wiper and washer. These wires will be added to the trucks harness that I am swapping with. Most of the swap was easy because the plugs that the wires went to on the tahoe were empty on the...

Some people sit around and knit................ Others sit around and...........

That is what I was worried about.... but with the 96 set up I do not see a place for it. Does it go on the passenger side head by the alternator? The AC bracket (drivers side) has a lift eyelet built in......I found a diagram that showed no spacers or other brackets, but a stud was used where I...

wholesalegmpartsonline has some great diagrams/parts breakdowns. Think I figured out my problem with the AC bracket. I was trying to use a bolt and it was supposed to be a stud.

I am running into similar problems trying to put together a 6.2 with a 1996 6.5 accessory setup. I think my problem though is forgetting/misplacing brackets and spacers since it was back in March when I pulled everything apart. Anyway if the main brackets are bolted straight to the heads, the...

Got one tranns cooler line hooked up and one fuel connection worked out, tonight. Moving like a sloth, but I'm movin........ I also tried to get the accessory brackets installed, but either I misplaced the bolts re-placed them with longer bolts or I am missing a spacer or another bracket cause...