-
Welcome to The Truck Stop! We see you haven't REGISTERED yet.
Your truck knowledge is missing!
- Registration is FREE , all we need is your birthday and email. (We don't share ANY data with ANYONE)
- We have tons of knowledge here for your diesel truck!
- Post your own topics and reply to existing threads to help others out!
- NO ADS! The site is fully functional and ad free!
Problems registering? Click here to contact us!
Already registered, but need a PASSWORD RESET? CLICK HERE TO RESET YOUR PASSWORD!
Search results
-
Crank no start
Replaced CPS truck fires up and runs without any codes.:)- snarl95
- Post #55
- Forum: GM 6.5 Diesel
-
What did you do with your GMT400 today...or yesterday....
Drove it.- snarl95
- Post #878
- Forum: GM 6.5 Diesel
-
Crank no start
I'm getting DTC 19. Would that be because of the pump replacement or do I need to replace the crank sensor.- snarl95
- Post #49
- Forum: GM 6.5 Diesel
-
What did you do with your GMT400 today...or yesterday....
Replaced ECM. It now starts with extended cranking and a code. But it runs.- snarl95
- Post #873
- Forum: GM 6.5 Diesel
-
Crank no start
ECM was bad. Truck takes some cranking but fires. Throws a code and will check that. But it now runs. Will probably need to advance pump and set timing.- snarl95
- Post #47
- Forum: GM 6.5 Diesel
-
-
What did you do with your GMT400 today...or yesterday....
cussed at it- snarl95
- Post #824
- Forum: GM 6.5 Diesel
-
Crank no start
Everything is plugged in. Had power to pin A1 and C1.- snarl95
- Post #43
- Forum: GM 6.5 Diesel
-
Crank no start
Not getting 1.2 volts out of green wire at ecm. Suggestions?- snarl95
- Post #41
- Forum: GM 6.5 Diesel
-
Crank no start
What's a pin drag test? What would I need to test for the square wave?- snarl95
- Post #40
- Forum: GM 6.5 Diesel
-
-
Crank no start
Did the testing all wires check out except 984 light green. I get 28-30 mv with key off. 4.9v with key on engine off. Crank .5-.6v Where should I look next?- snarl95
- Post #34
- Forum: GM 6.5 Diesel
-
6.5 turbo diesel
Test your coolant for combustion gases. Do you have any coolant loss?- snarl95
- Post #4
- Forum: GM 6.5 Diesel
-
Crank no start
How long does it take to purge air from system after pump swap?- snarl95
- Post #28
- Forum: GM 6.5 Diesel
-
Lift pump wiring ?
Could I just run the lift pump off a toggle switch?- snarl95
- Post #11
- Forum: GM 6.5 Diesel
-
Lift pump wiring ?
I could but I don't want to. They used a snap together clip.- snarl95
- Post #8
- Forum: GM 6.5 Diesel
-
Lift pump wiring ?
Previous owner spliced into the fuel shutoff solenoid to run the lift pump. I had to cut the wire that was spliced in.- snarl95
- Post #4
- Forum: GM 6.5 Diesel
-
Lift pump wiring ?
While replacing my injection pump I had to cut a wire that was spliced into the FSS. Apparently it was for the lift pump as it no longer works. So I need a wiring diagram or someone to tell me where I can reconnect that wire.- snarl95
- Thread
- Replies: 12
- Forum: GM 6.5 Diesel
-
-