Search results

Just dont hard boil them egggs furst. BWAHAAAAhaaaaaa

But I want to see into combustion chambers. Is there a GP/video camera option ? ? ? ? 😹😹😹

I read that google search, about the saran wrap, while at my friends, we both thought that was funny, but, would certainly keep dirt out of that CV joint.

1988 Buick. NAPA was factory on axle and ball joint, plus at least a week out and postage stamps. Oriellys will be here Wednesday He said, Unless Orielly is shutting down on Monday for some reason, usually its Tuesday after ordering on a Saturday. Axle is Precision brand, same with ball joint...

Yup, 😹😹😹 It struck a funny note in me too. But, good infurmaishun. 😹😹😹

Yup, got the car in the garage. Lower right Ball Joint shot and the CV axle boot on left side. Decided to replace the entire CV axle. Been a lot of years ago that the right side CV axle was replaced so I’ll call oriellys and see if they still stock that same brand and get one for the left side too.

I’m not familiar with such as all of that. Looks like a couple of the 👍 buttons been touched on Your previous post by a couple reliable sources so that must be an option, ball joint spacers. Also might be an option to contact the company that builds the spacers and see if thats a viable option.

The mechanicals of the axle seems to be ok. No bad noises or such. No clunking or vibrations. Just a torn outer boot. I have not yet removed the shaft from the car to verify the aforementioned conditions but it will happen today, I think. Anyhow, if the CV joint checks out is it worth it to...

Welcome to the forum ML.

😹😹😹😹

I love that truck.

I wonder if a smaller pulley could help boost things up a little.

I’ll hold off in the loads until I get this figured out and fixed. I was afraid of the lowered boiling points with it not being pressurized. Got plenty to do here until that time comes to move them old dozers from up north. And then the son bought a smaller road grader. It is over in Ohio. We...

No more drips under the truck. I’ll be needing to pull a heavily loaded trailer about 60 to 70 miles before too long. I hope its okay to haul such a load with the radiator cap loose. Weight on the trailer will be in excess of 20,000 pounds. Some mighty fine hills between there and here too. Any...

Yes. All the spun bearings I have seen the engine does not run for long after the bearing spins. Ones I have taken apart with spun bearing the bearings stack and the engine stalled. The tang on the bearing is always wiped off. Two of those engines git the crank ground under, new bearings, back...

Seems there is a sort of a rubber sleeve on them disk brake guide pins.

And no smoke. 👍👍👍

I woonder if line boring would make bearings all one size, most likely not as thats mostly on journal diameters.

Fir sime reasin my Os becimes i so please imprivise. 😹😹😹😹

Use the blow gun and blast iff as much of the dirt as possible. Wire brush and screw drivers helps. Partially unscrew the hold down nut and blast it some more. Repeat until the nut is relieved if its ramps, then hold down the SU and blow it off some more. IIRC, maybe the new pendulum unit might...