Search results

Silicone grease is recommended on brake parts, such as the guide pin boots but I am unsure if they are rubber. I doubt anything was used the last time it was out.

Should the O-ring for the seal be replaced while it's out or just reuse the one already on the tank?

I was hoping the tank module was in good shape and it appears to have been greased up way back when it was out before.

I was going to drop it out on the ground but dad talked me into putting it in the air. We sat the rear down on the stands in the picture and had the front sitting on a piece of wood across two of the arms. That allowed enough space to disconnect the supply and return lines. In case someone...

Well, the tank is out.

The clip is exactly as you described, Les. I was just looking for the proper tool to release it. I've pulled the clips out before but I didn't recall the cover. Does the cover need to be replaced? I wasn't sure if it was a one time use piece. Also, I guess we already have a set. I just...

Either one is likely to cause damage in the form of plugging up things you don't want plugged up, long term. If you need the truck right away then I would replace the offending part rather than pour either chemical in. Then you can address any potential warranty issues with the leaking part in...

I ran most of the fuel out last fall. I think last time we used a floor jack or two

This is the plastic cover I am asking about

To remove these clips

I'm looking for a set of the quick disconnect tools for transmission lines. Can someone recommend a set? In particular, I'll be using them on a 2005 Tahoe to start with. Also, do the plastic covers need to be replaced if the lines are disconnected?

It showed up today. I checked the bolts on the straps for the tank and I can loosen then without issue so as soon as I have an opportunity, I'll be letting the tank down.

Copy that. Metrum rod due to show up today or Monday.

What part of Ohio @Lucas5475 ?

Welcome

Welcome

Just think, somebody thought that was a good idea..

Just put heat shields around them if they run up through the cabin area <grin>

Now we know a guy that can turn rotors!

How many micron is the OEM sock?