Search results

My low side keeps leaking even with a new schrader. Can't get it to stop

It mainly depends on how many parts you get out of a scrap yard and the cost they charge. I got a NV4500 out of a local scrapyard for $80. Got the bell housing, cross member, clutch, and flywheel for $200. Had to go to a different scrap yard to get the pedal and master cylinder. Ended being like...

Pump is only 3 months old and filter is only 2 months old. Ill test for pressure as soon as I can

New problem. Went to start the truck and it won't even start now.

Found one for $20 at harbor freight I’ll go get tonight. If the fuel pressure is normal, are the injectors the problem? Fuel pump was changed in January

I was thinking about taking the upper intake off to look at them. I’ve been planning on getting the upgrade for awhile. Could it be the ecm by any chance? I can go to the scrap yard and get one cheap. I just don’t have a fuel pressure gauge so the only way is to physically look at them. Come to...

This is the inside of the cats. Ain’t nothing 😂

Here recently my 98 has been acting up once again. It started out as just a little miss at full throttle and now it’s turned into no power at all. It will run fine at idle and idle up perfect in neutral. If you put it in gear and try to drive it, it instantly loses all power and hogs down...

We have a big air compressor cabable of running a 1 inch impact so I think it should be fine. Do you know what the cost of one is?

It doesn’t have any creases just a dent. I’ll post a picture of the truck. I don’t have a picture of it when the can was smashed but it was so bad you couldn’t sit on the passgener side. Guy I got it from bought it and had it hauled to his place. Drove it down the driveway and parked it by his...

My 83 had a tree fall on the cap back before I bought it. All it did was bust the windshield and fold the roof in. It fell diagonal across the cab from the passenger front corner to the driver side rear corner. I took a bottle jack and pushed the roof back up and the windshield actually fit back...

Ok it was just a wild idea but I may have come up with a wilder one lol

I know I might sound crazy but how hard would it be to put the old dash in a new dash truck? I have a vortec 350 so will it even work? I need a new dash and I prefer the old dash over the new.

Ok, tomorrow afternoon I get a meter and test the wires like you mentioned and let you know what I've got.

I do have a buzzing needle sometimes. Could that point at anything? It does it very rarely

Ok it has to be the pcm. Has a new fuel pump and it dies the same thing as the old one. Also a new gauge cluster and I still have the same problem

Ok thank you so much I’ll get something firgured out

Purple wire must be the wrong one - still bot working. If you don't mind and it has it let me know what wire is the right one. I have no idea how to test it with a volt meter or any other way to figure out which wire is the right one.

Ok I do have a purple wiring at the balance module. I'll hook it to my blue/black wire and see if it reads.

Thats what I want to try to do. Do you know which wire goes from the balance module to the ecm that I need to hook to?