Search results

Are you referring to the metal line in front of the IP, to rubber fuel hose, to front of IP?

Yes, the vibration is only with the new engine. Timing and actual timing is set. I did install a new Fluidampr (electronic). I also installed a new crank pulley (original GM). I will check damper and injection timing. Thank you

Thank you for the link.

Thanks Will L. I will give it a go. I'm trying to chase down a vibration. I have just installed a factory new GEP motor. I have replaced most everything and I have a pretty decent vibration. I have already checked for air in the fuel, and fuel flow each seem fine. Thought I would disconnect the...

Greetings, Does anyone know of flex plate turning tool for the 6.5 diesel? All I get on a Google search is small block GM stuff. Also, is there a "holding tool " for the same engine, got the big nuthin on that as well.

Mine cracked inside the #8 cylinder. My year (98') was more prone than yours. Mine too had the same symptoms which is why I mentioned it. It would start and run rough for 10 seconds or so after leaving it overnight. And, like yours sometimes it wouldn't do it at all. I have since determined that...

I would remove and CLEAN all the ground wires and studs they connect to. Also, I would make sure that your charging system is fully charging good batteries. I would do this prior to worrying about the codes. As far as the smoke, I would check for a cracked block. Mine had the same symptoms...

I believe that the torque converters are different plus, I'm with AK on this one. The smaller transmission won't hold up. Suggestion: since you already have a 6.5 ready to go, why not just find another truck (they're out there) that's already a diesel that has a bad motor? That way you can have...