Well now, that gives me another place to turn this thing 88 different ways. Man you have certainly helped me out. I will try to finish that part and the exhaust tomorrow. I've got to complete at least 2 so I can park something else in the garage.
I do appreciate the time and effort you put in...
Thank y'all for the help!!. This poor truck has suffered at the hands of every jack-leg in the state. I purchased the truck from a shop for what was owed on it ( $1000.00 ). It is a nice looking truck outside and inside and also has both front and rear drive shafts with a newly remaned transfer...
Sorry buddy, I forgot to addine is a gas job. If you will please post a pic. of what you have. Long story behind this truck. Thanks again for your help, Richard .
Mine is about 4 inches long by maybe 2 inches high. I better say the heat shield is those measurements instead of "Mine is". Don't want people to think I'm bragging you know. It also has a little bit of a crooked bend which in the middle, not much of a croock. AGAIN, I'M TALKING ABOUT THE HEAT...
Hello Will, MrMarty,Warwagon and everyone else. I've been away for a long time but hope everything has leveled out with me now. I'm back to finishing the 96 k2500 Silverado after an almost complete re-wire job. There is a metal heat shield that bolts somewhere around or below the exhaust...
Well I haven't died yet but I think I would have felt better had I. I haven't been on my tablet but just a few times to read when I couldn't sleep. I want to thank you all for the prayers and best wishes.
On a better note I did find everything I need to build the Clevor we talked about. It ain't...
I wanted to begin my build book last evening but life happens. This double pneumonia has me feeling a little on the low side so I'm not sure if I can start it today.. Richard